Anderson Composites C8 Corvette Carbon Fiber Rear Diffuser Fins

The one page instructions that comes with the parts has very little details. The pieces are not marked and when you take them out of the bags you can get them mixed up. The picture of the parts does not help very much, but the inner pieces are the easiest to figure out. the studs on the passenger side outer were not aligned properly and did not go thru the screen holes like the other 3 pieces. Ended up opening up the holes to get the studs thru. It was not a quick job like I first thought. The diffusers do look good when they are installed.

What I like about these defusers is that they don't look like an add on, they look like they came from the factory that way, and make the back look more sporty!

First off I’m not a rookie at modding cars...I was able to install despite the worst directions I’ve ever seen. A simple template in screened section would help immensely...without that you will scratch the paint on the grill if you don’t find the right holes first time...also the top screw threads had resin on them so bolts would not tighten...had to run a tap over to clean the threads...what shoulda been a 15 minute install took over a hour with lots of measuring...low rating only due to directions...